Problems at HX-20 Restart

C'est la catégorie reine de l'ordinophile, 8 bits et pas un de plus!
Single board ou bus S-100 acceptés.

Modérateurs : Papy.G, fneck, Carl

LVX
Messages : 1
Inscription : 20 mars 2023 15:44

Problems at HX-20 Restart

Message par LVX »

Merci de m'accueillir au forum
Retraité, je retrouve dans les systèmes 8 bits, de quoi faire passer ma nostaligie des systèmes que j'ai pu et dû utiliser (laboratoires didactiques de chimie-physique ) fin des années 70 et début des années 80.
Afin de rejoindre le plus grand nombre, je poursuis la description de mon problème de redémarrage d'un Epson HX-20 en anglais.

After many trials and following troubleshooting tips suggested, the system display remains after many attemps, as follow:

-
----------------------------------------
Break
----------------------------------------
A=10 B=BD X=E0D7
----------------------------------------
C=D9 S=0112 P=011B
----------------------------------------
The system behaves as this:
Start by switch on : display appears after the "beep" tone" that I interpreted as encouraging, but:

Switch off doesn't clear the screen
Push on the reset button clears the screen

Some info about the machine:
Serial: 010884.
Should be running BASIC V1 and has the opening over the 6301 VOP C63010 CA
Basic M64030AA ROMS:
ROM0: A2X145
ROM1: A2X144
ROM2: A2X139
ROM3: A2X140
ROM4: Empty
RAM 0,1,2,3: M16010C (x4)
Dip switch settings: OFF ON ON OFF : French Keyboard (Membrane type)
Power supply: new sub-Cells (1500mAh) installed; recharged using the original transformer.
Battery circuit checked up to the capacitors
Flexprint and other flat ribbon cables checked.

Any suggestions are welcome and I would be more than happy to see this machine up-and-running again.
Many thanks in advance.

Andre
Zebulon
Messages : 2787
Inscription : 02 nov. 2020 14:03

Re: Problems at HX-20 Restart

Message par Zebulon »

Bienvenue sur le forum. Il semble qu'il soit bien planté. Il n'affiche même pas le menu 1-MONITOR et 2-BASiC ? CTRL-@ n'a pas d'effet au démarrage ? Il faudrait vérifier les contacts des puces ROM.
Répondre